There are seven types of forklifts, grouped into Classes I through VII in OSHA's forklift classification eTool. The Industrial Truck Association grouped them by power source, tire type, and the job each truck does. Know your floor surface and your loads, and you can usually narrow the choice to one or two classes.
What Are the 7 Types of Forklifts?
There are seven types of forklifts, and Classes I through III are all electric: rider trucks, narrow aisle trucks, and hand trucks. Classes IV and V are engine trucks on cushion or pneumatic tires, Class VI covers tractors, and Class VII covers rough terrain forklifts.
The class list comes from the Industrial Truck Association, and OSHA uses it in training materials. The actual rule, OSHA 29 CFR 1910.178, is broader. It covers fork trucks, tractors, platform lift trucks, motorized hand trucks, and other specialized industrial trucks, so some equipment falls outside the seven-class list.
Here is how the classes compare at a glance.
| Class | Power | Tires | Typical Equipment | Best Environment |
|---|---|---|---|---|
| I: Electric Motor Rider Trucks | Electric (battery) | Cushion or pneumatic | Sit-down and stand-up counterbalanced forklifts, three-wheel electrics | Indoor warehouses and docks; dry outdoor areas with pneumatic tires |
| II: Electric Motor Narrow Aisle Trucks | Electric (battery) | Solid | Reach trucks, order pickers, turret trucks, side loaders | Dense racking and narrow aisles |
| III: Electric Motor Hand or Hand/Rider Trucks | Electric (battery) | Solid | Powered pallet jacks, walkie stackers, rider pallet trucks | Docks, staging areas, short horizontal runs |
| IV: Internal Combustion Engine Trucks (Solid/Cushion Tires) | LP gas, gasoline, or diesel | Cushion | Counterbalanced LP gas cushion tire forklifts | Smooth, dry indoor floors with ventilation |
| V: Internal Combustion Engine Trucks (Pneumatic Tires) | LP gas, diesel, or gasoline | Pneumatic | Counterbalanced pneumatic tire forklifts | Yards, docks, and mixed indoor and outdoor surfaces |
| VI: Electric and Internal Combustion Engine Tractors | Electric or engine | Cushion or pneumatic | Sit-down tow tractors | Towing carts and trailers along set routes |
| VII: Rough Terrain Forklift Trucks | Engine (often diesel) | Pneumatic, large tread | Vertical mast rough terrain forklifts, telehandlers, truck-mounted forklifts | Construction sites, lumber yards, unpaved ground |
Class I: Electric Motor Rider Trucks
Class I trucks are battery-powered forklifts the operator rides, either seated or standing. They are counterbalanced, meaning the weight at the back offsets the load on the forks.
OSHA's eTool lists sit-down and stand-up counterbalanced riders and three-wheel electric trucks in this class, shown with cushion tires and with pneumatic tires. In practice, pneumatic models handle dry outdoor pavement better, while cushion models are built for smooth indoor floors.
With no engine exhaust, Class I suits food warehouses and other buildings where air quality matters. You trade fuel stops for battery charging, so check your charging space and shift schedule first. Browse electric forklifts for sale, or see the Crown forklifts we carry.
Class II: Electric Motor Narrow Aisle Trucks
Class II trucks are electric forklifts designed to work in tight aisles and stack loads high in racking. If you want more storage in the same building footprint, this is the class to study.
The class includes reach trucks, order pickers, turret trucks, and side loaders. A reach truck extends its forks forward to place pallets into racking. An order picker lifts the operator with the platform, so they can pick individual cases at height.
These trucks run on small solid wheels and need flat, level indoor floors. Before you choose one, measure your aisles and rack heights, which we cover below.
Class III: Electric Motor Hand and Hand/Rider Trucks
Class III trucks are electric pallet movers the operator walks behind or rides at low height. They handle short runs, like unloading trailers or moving pallets across a dock.
Powered pallet jacks and walkie stackers are the most familiar Class III trucks. A walkie stacker can lift a pallet onto low racking, while a pallet jack only raises the load enough to move it. Most of these trucks are compact enough for retail backrooms and crowded staging areas.
Class III works best as a support truck. Many operations pair one with a Class I or Class IV forklift, so the main truck stays on lifting work. A manual pallet jack has no motor, so it falls outside the classes entirely.
Class IV: Internal Combustion Cushion Tire Trucks
Class IV trucks are engine-powered forklifts on solid cushion tires, built for smooth, dry indoor floors. Most run on LP gas (propane), which lets you swap a tank and keep working.
Cushion tires sit low and give the truck a tight turning radius. That suits warehouses and manufacturing floors with good concrete. Shop cushion tire forklifts if your floors fit that description.
LP gas engines produce exhaust, so ventilation matters indoors. Check your building's airflow and your site rules before you commit to propane in an enclosed space. If ventilation is limited, a Class I electric truck is often the better match.
Class V: Internal Combustion Pneumatic Tire Trucks
Class V trucks are engine-powered forklifts on pneumatic tires, built for outdoor yards and uneven ground. They run on LP gas, diesel, or gasoline, depending on the model.
Pneumatic tires are larger and absorb bumps that would rattle a cushion tire truck. That is why lumber and building supply yards rely on this class. Browse pneumatic tire forklifts if your loads move across gravel, asphalt, or broken pavement.
Many Class V trucks can also work indoors, so they suit operations that move between a yard and a warehouse. Ventilation rules still apply inside. If you want a familiar brand, our used Toyota forklifts page lists the models we have now.
Class VI: Electric and Internal Combustion Tractors
Class VI trucks are tractors that tow loads instead of lifting them. They pull carts or trailers, so they are useful when you move material in trains along a set route.
You will see tow tractors in operations that move carts over long routes. They come in electric and engine versions, with cushion or pneumatic tires. OSHA's eTool also shows some tractors under Class III, the electric hand/rider class.
If your problem is distance rather than height, a tractor may replace several forklift trips.
Class VII: Rough Terrain Forklift Trucks
Class VII trucks are rugged forklifts built to work outdoors on unimproved ground, like dirt or gravel construction sites. They run on large pneumatic tires and are often diesel powered.
OSHA's eTool describes three basic types of rough terrain forklift:
- A vertical mast type looks like a heavy-duty forklift and lifts straight up.
- A variable reach type uses a telescoping boom to place loads forward and up, and the industry often calls it a telehandler.
- A truck or trailer mounted type rides on the back of a delivery truck and unloads at the job site.
OSHA also notes that not every truck-mounted forklift counts as rough terrain equipment. If your work is on a job site, start your search in this class.
How to Choose the Right Forklift Type
Start with the job, then let your floor and your building narrow the class. The four checks below rule out most of the list quickly.
Start With Your Floor
Your floor surface decides your tire type, and tire type often decides the class. Smooth indoor concrete points to cushion tires (Class I or Class IV).
Gravel, asphalt, or mixed surfaces point to pneumatic tires (Class V, or Class VII on rough ground). Our guide to cushion vs. pneumatic tire forklifts walks through the tradeoffs.
Match Power to Your Shifts
Electric trucks need charging time and a place to charge. LP gas trucks refuel with a tank swap but produce exhaust, so indoor use depends on ventilation and site rules. Count your shifts per day and note where the truck will spend its time.
Then read our comparison of electric vs. LP gas forklifts before you decide.
Measure Aisles and Rack Height
Measure before you shop. Write down your narrowest aisle width, your top beam height, your door openings, and any overhead obstructions like lights or sprinklers.
Then note your heaviest load and its size. Rated capacity depends on load center, lift height, mast, and attachments, so a truck may not lift its full rated capacity at full height. Share those numbers when you ask for a quote, because a spec sheet alone can't tell you whether a truck will work in your aisles.
Check Hazardous Location Designations
If you handle flammable vapors or combustible dust, you also need the right designation. A designation differs from a class. The class describes the truck's design, while the designation describes the safeguards it has for hazardous locations.
OSHA's enclosed and hazardous areas eTool lists 11 designations under 1910.178(b). Letters stand for the power type, such as D for diesel, E for electric, G for gasoline, and LP for liquefied petroleum gas. Versions like DS and ES add safeguards, and EX trucks have electrical fittings designed for atmospheres with flammable vapors or dusts.
Check the designation on the truck's nameplate against your site's hazard classification. Your safety team or insurer should confirm what your location requires.
How LiftWorks USA Helps You Find the Right Class
We help you match your job to a class, then find a unit in the condition and budget that fits. Our current forklift inventory spans electric and engine-powered equipment across many of the classes in this guide.
Condition Tiers, Explained Plainly
We sell four condition tiers, and they are different products. Refurbished units are rebuilt and tested through our refurbishment process. Wholesale, Rent-Ready, and As-Is units do not get the full refurbishment unless your sales agreement says so.
Our 120-day parts and labor warranty applies to refurbished equipment only. If you buy a Wholesale, Rent-Ready, or As-Is unit, check your written quote for what coverage, if any, applies.
Quotes, Freight, and Payment Options
Quotes come back in about 15 minutes. We'll verify the condition report, availability, configuration, and warranty terms, then put the complete details in a written quote.
We ship freight to all 48 contiguous states and offer export crating for international buyers. Financing is available, and you can trade in equipment you no longer need. Delivery timing is confirmed in your quote.
Frequently Asked Questions
These are short answers to the questions buyers ask us most about forklift classes.
How many types of forklifts are there?
There are seven types of forklifts, numbered Class I through Class VII in OSHA's training materials. The Industrial Truck Association created the list and grouped trucks by power source, tire type, and the job each truck does. Each class contains several truck styles, such as reach trucks and order pickers in Class II. OSHA's forklift standard, 29 CFR 1910.178, also covers some industrial trucks that fall outside the seven-class list.
What is the most common type of forklift?
The counterbalanced sit-down forklift is the design most buyers picture when they think of a forklift. It shows up as an electric truck in Class I and as an engine truck in Classes IV and V. We don't quote market-share figures because we haven't seen a reliable public count. The more useful question is which class fits your floor and your shift pattern.
What class is a reach truck, pallet jack, or telehandler?
A reach truck is Class II, a powered pallet jack is Class III, and a telehandler is Class VII. OSHA's eTool describes a variable reach type of rough terrain forklift with a telescoping boom, which the industry commonly calls a telehandler. It also lists reach-type outrigger trucks under both Class II and Class III, so check the truck's data plate. A manual pallet jack has no motor, so it falls outside the classes.
Can electric forklifts be used outdoors?
Some can, if they have pneumatic tires and the ground is dry. OSHA's eTool shows Class I riders with cushion tires and with pneumatic tires. In practice, pneumatic models handle dry outdoor pavement better, while cushion models are built for smooth indoor floors. For wet ground, gravel, or rough yards, look at Class V or Class VII engine trucks instead. Confirm the unit's tire type and configuration in your written quote.
What is the difference between Class IV and Class V forklifts?
Class IV and Class V are both engine-powered forklifts, and the difference is the tires. Class IV trucks run on solid cushion tires for smooth, dry indoor floors. Class V trucks run on pneumatic tires for outdoor yards, docks, and uneven ground. If either truck works inside on propane or another engine fuel, plan for ventilation and follow your site rules.
Does OSHA forklift certification cover all forklift classes?
No, operator training has to match the types of trucks each operator will drive. Under 29 CFR 1910.178(l), employers train and evaluate each operator, then certify that the training happened. Training must cover the truck types the operator uses. OSHA also requires refresher or additional training when an operator is assigned to a different type of truck, under 29 CFR 1910.178(l)(4). Treat this guide as buying guidance, and leave operator training to your employer's program.
Find the Right Forklift Class for Your Operation
The right forklift starts with the job and the floor it runs on. Once you know your class, you can compare individual units by condition and configuration.
Have your measurements and load details ready, then call us at 805-601-7081 or request a quote. We'll confirm what's available and put the details in writing.
Explore More Forklift Guides
Browse all guides in our Forklift Insider blog, or explore available forklifts.